Medical Latex Finger Cot NML-AMTT Size No. 2 5 pcs.

Intended for the protection and isolation of fingers from injuries or for protecting already damaged skin from contamination and bacterial infection. Used in medical and preventive institutions as well as in everyday life.

Finger cots can be used no less than three times.
Before use, finger cots must undergo a processing cycle, including disinfection, pre-sterilization treatment, and chemical sterilization.
Disinfection of finger cots is performed by boiling in distilled water for 30 minutes.
Pre-sterilization treatment is carried out by soaking the finger cots in a cleaning solution consisting of 17 cm³ of hydrogen peroxide, 5 g of detergent ("Progress," "Lotus," "Aina," "Astra"), and 978 cm³ of drinking water for 15 minutes at a temperature of 50°C, followed by rinsing with running water for 10 minutes.
For sterilization, finger cots are immersed in a 6% aqueous solution of hydrogen peroxide at a temperature of at least 18°C for 360 minutes. After exposure in the solution, finger cots are rinsed with sterile water for at least 30 seconds and used as intended.
To prevent sticking between processing cycles, finger cots should be treated by immersion in a 5% suspension of a physiologically harmless substance.

Made from natural latex, in accordance with the requirements of TU 9398-005-53757884-2008

Attention! The product is made of latex, which may cause an allergic reaction.
Individual intolerance to the materials of the product.

Before use, please read the instructions.

Storage conditions
The packaged finger cots should be stored at a temperature of 0° to +25°C and relative humidity not exceeding 80%, stacked in piles no higher than 1 m and at least 1 m away from heating appliances.
During storage, the finger cots must be protected from direct sunlight and not exposed to oils, gasoline, and other substances that can destroy rubber.

Disposal
After the expiration of the service life or expiration date, dispose of as household waste.

MEDICAL LATEX FINGER COTS NML-AMTT - designed for the protection and isolation of fingers.

Size: 2

Finger cots are made in light colors, with the edges rolled into a cuff. The surface of the finger cots must be free of holes, cracks, and punctures, and to prevent sticking, treated with a physiologically harmless powder (talc, kaolin, or other means). The finger cots must withstand a three-cycle processing according to MU 287-113, including disinfection, pre-sterilization cleaning, and chemical sterilization.

PHYSICAL-MECHANICAL PROPERTIES OF FINGER COTS BEFORE AND AFTER PROCESSING:

Tensile strength, MPa (kgf/cm²), not less than:

Before processing......17.5

After processing.....15.00

Relative elongation at break, %, not less than:

Before processing....750

After processing....650

Relative residual elongation after break, %, not more than:

Before processing....15

After processing....20

CHARACTERISTICS:

• made of natural latex approved for use by the Ministry of Health of the Russian Federation

• safe for human health during operation.

• can be used at least three times.

• resistant to multiple disinfections, pre-sterilization cleaning, and sterilization.

• guarantee storage period - 3 years

• guarantee operational period - 1 month

Dimensions of the finger cot:

• width - 28+/-2 mm;

• length - not less than 70 mm;

• film thickness - 0.15-0.30 mm.